seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Supercharger pressure sensor G31 with intake air temperature sensor G42 : Removing and installing, vehicles with engine codes > < Intake manifold flap motor V157 : removing and fitting, vehicles with engine identification letter BMN

Leon Mk2

Engine speed senderG28: removing and fitting
Engine speed sender -G28-: removing and fitting
t  Removing → Anchor
t  Fitting → Anchor
t  Tightening torque → Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  AF-4mm wrench -T10370-, see equivalent → Anchor
  W00-10582
Removing
–  Remove the oil filter bracket → Chapter.
–  Disconnect electrical connection -arrow- from the engine speed sender -G28-.
  Note
To disconnect the electrical connection, press on the engine speed sender using a screwdriver and at the same time lift the release tab using a thin wire hook.
  A23-0205
–  Unscrew the fixing bolts -2- using the AF-4mm wrench -T10370- and remove the engine speed sender -G28--Item 1-.
Fitting
Installation is carried out in the reverse order of removing, when doing this note the following.
–  Fit the oil filter bracket → Chapter.
Tightening torque
  A23-0209
ComponentNm
Engine speed sender -G28- to the engine block5

   

Supercharger pressure sensor G31 with intake air temperature sensor G42 : Removing and installing, vehicles with engine codes > < Intake manifold flap motor V157 : removing and fitting, vehicles with engine identification letter BMN