seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Intake manifold flap motor V157 : removing and fitting, vehicles with engine identification letter BMN > < Air mass gauge G70 removing and fitting

Leon Mk2

Intake manifold flap motorV157: Removing and installing, vehicles with engine codes AZV - BKD
Intake manifold flap motor -V157-: Removing and installing, vehicles with engine codes AZV - BKD
t  Removing → Anchor
t  Fitting → Anchor
t  Specified torques → Anchor.
   
Removing
Engine cover (version 1):
–  Take out the oil dipstick -1- from its guide tube.
–  Lift the engine cover sideways -arrows 2- and extract to the front -arrow 3-.
–  Replace the oil dipstick in the guide tube.
  E10-10002
Engine cover (version 2):
–  Detach the outer -1- and inner -2- engine covers, by pulling them evenly upwards.
All vehicles (continued):
  E10-10038
–  Unplug electrical connector -2- at air mass meter -G70-.
–  Disconnect the breather hose -1- and the air conduit hoses -3- and -5-.
–  Screw out bolt -4- and detach air cleaner housing.
  A10-1667
–  Unscrew the join tube -arrow-.
  A15-0914
–  Remove bolts -5-.
–  Disconnect electrical connection -6- from the intake manifold flap motor -V157-.
–  Disconnect the coolant hose -3- from the mechanical exhaust gas recirculation valve.
–  Release the air hose from the intake connection pipes, lifting the retention clip to do so -1-.
–  Unscrew the bolts -2- and -4- and remove the connection tubing from the intake manifold along with the exhaust gas recirculation valve.
Fitting
Installation is carried out in the reverse sequence; note the following:
  Note
t  Renew gaskets and seals.
t  Secure all hose connections with the correct hose clips (same as original equipment) → Spare parts catalogue.
–  Fit the charge air system lines, follow the instructions during this → Chapter.
Specified torques .
  A15-0915
ComponentNm
exhaust gas recirculation mechanical valve to intake manifold.10
Exhaust gas recirculation connecting pipe to mechanical exhaust gas recirculation valve22
Exhaust gas recirculation connecting pipe to connection tubing10
Intake manifold flap motor -V157- to mechanical exhaust gas recirculation valve10

   

Intake manifold flap motor V157 : removing and fitting, vehicles with engine identification letter BMN > < Air mass gauge G70 removing and fitting