Leon Mk2
Note
|
| 1 - | Bolt. |
| q | 8 Nm |
| 2 - | ABS rev. sensor |
| q | Before fitting the sensor, clean interior surface of opening and apply solid lubricating paste -G 000 650- |
| 3 - | Wheel bearing housing |
| 4 - | Protective plate |
| 5 - | Bolt. |
| q | 12 Nm |
| 6 - | Wheel hub |
| Releasing and inserting → Running gear, steering axles; Rep. gr. 40 |
| 7 - | Brake disc |
| q | Thickness 25 mm |
| q | Wear limit: 22 mm |
| q | Always replace by axles |
| q | To remove it, unscrew the brake callipers beforehand |
| q | Do not use force to separate the brake from the wheel stock, use deoxidant if necessary, as the brake disc could be damaged. |
| q | Clean and grease the contact surface between the wheel hub and the brake disc. De-grease and clean the brake discs when fitting. |
| 8 - | Bolt. |
| q | 4 Nm |
| 9 - | Brake pads |
| q | Thickness 14 mm |
| q | Check the thickness → Precision maintenance |
| q | Always replace all the pads on each axle |
| q | Removing and installing → Chapter |
| 10 - | Retaining spring |
| q | Insert into the two holes in the brake calliper housing |
| 11 - | Brake back plate |
| 12 - | Brake caliper |
| q | Do not unscrew the brake line when replacing brake pads |
| q | Removing: |
| – | Remove the brake pads → Chapter. |
| – | Place the block on the brake pedal. |
| – | Loosen hose from the brake calliper. |
| q | Installing: |
| – | Fit the brake pads → Chapter. |
| – | Screw the hose to the brake calliper. |
| – | Remove the block from the brake pedal. |
| – | Bleed brake system → Chapter. |
| 13 - | Guide pin |
| q | 28 Nm |
| 14 - | Protective cap |
| q | Removing |
| 15 - | Brake hose with hose connection and hollow bolt |
| q | 35 Nm |
| 16 - | Bolt. |
| q | 125 Nm |
