Leon Mk2
Note
|
1 - | Brake disc |
q | Thickness: 22 mm |
q | Wear limit: 19 mm |
q | Always replace by axles |
q | To remove it, unscrew the brake callipers beforehand |
q | Do not use force to separate the brake from the wheel stock, use deoxidant if necessary, as the brake disc could be damaged. |
q | Clean and grease the contact surface between the wheel hub and the brake disc. De-grease and clean the brake discs when fitting. |
2 - | Bolt. |
q | 4 Nm |
3 - | Brake pads |
q | Thickness: 14 mm |
q | Check the thickness → Booklet |
q | Do not unscrew hose when replacing brake pads |
q | Removing and installing → Chapter |
q | Always replace all the pads on the same axle |
4 - | Brake caliper |
q | Do not unscrew hose when replacing brake pads |
q | Removing and installing → Chapter |
q | Remove the brake pads → Chapter. |
5 - | Guide pin |
q | 30 Nm |
6 - | Protective cap |
q | Remove |
7 - | Retaining clip |
8 - | Brake hose with hose connection and hollow bolt |
q | Tightening torque for bolt: 35 Nm |
q | Do not dismantle, replace complete |
q | Do not unscrew to change the brake pads |
9 - | Wheel hub with wheel bearing |
q | Sensor ring integrated into the wheel bearing |
q | Replace after each removal, as it is destroyed on removal |
q | Removing and installing: → Running gear, axles, steering; Rep. gr. 40 |
q | Allocation: → Parts catalogue |
10 - | Bolt. |
q | 12 Nm |
11 - | Cover plate |
12 - | Wheel bearing housing |
13 - | ABS rev. sensor |
q | Before fitting the sender, clean the inner surface of the hole and apply solid lubricant paste according to the → Parts catalogue. |
14 - | Bolt. |
q | 8 Nm |
q | For ABS revolution sensor |