Leon Mk2
1 - | Bolt. |
q | 8 Nm |
2 - | ABS rev. sensor |
q | Before fitting the sensor, clean interior surface of opening and apply solid lubricating paste -G 000 650- |
3 - | Wheel bearing housing |
4 - | Protective plate |
5 - | Bolt. |
q | 12 Nm |
6 - | Wheel hub |
Releasing and inserting → Running gear, steering axles; Rep. gr.40 |
7 - | Brake disc |
q | Thickness 25 mm |
q | Wear limit: 23 mm |
q | Always replace by axles |
q | To remove it, unscrew the brake callipers beforehand |
q | Do not use force to separate the brake from the wheel stock, use deoxidant if necessary, as the brake disc could be damaged. |
q | Clean and grease the contact surface between the wheel hub and the brake disc. De-grease and clean the brake discs when installing. |
8 - | Bolt. |
q | 4 Nm |
9 - | Brake pads |
q | Thickness 16.5 mm (including back plate) |
q | Check the thickness → Precision maintenance |
q | Always replace all the pads on each axle |
q | Removing and installing → Chapter |
10 - | Retaining spring |
11 - | Brake caliper |
q | With: |
t | 2 fastening screws. Tightening torque: 17 Nm. |
t | 2 bleeder screws. Tightening torque: 17 Nm. |
q | Do not unscrew the brake line when replacing brake pads |
q | Removing and fitting: → Chapter |
12 - | Retaining pin |
13 - | Brake hose with hose connection and hollow bolt |
q | 35 Nm |
14 - | Bolt. |
q | 125 Nm |