SEAT Workshop Service and Repair Manuals > Leon Mk2 > Running gear | Brake system: | Brake, brake mechanics | Front wheel brake: repairs | FS-III brake disc: Removing and installing.

Installation

Installation is carried out in the reverse sequence; note the following:

Always use new bolts → ETKA.

Note

t	Clean and grease the contact surface between the wheel hub and the brake disc. De-grease and clean the brake discs when fitting.

t	If applicable, remove soiling and corrosion present on contact surfaces between brake support plate and brake pads.

–	Install brake disc and screw in mounting bolt -arrow- while holding brake disc in the process. Tightening torque: → Chapter.

–	Install brake pads → Chapter.

SEAT Workshop Service and Repair Manuals