seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing brake master cylinder, right-hand drive vehicles

Leon Mk2

Removing
Removing
–  Note or request radio code on vehicles with coded radio if necessary.
–  Disconnect battery. → Electrical system; Rep. Gr.27.
   
–  Remove trim/air duct -1--arrows-.
–  Remove air filter, in vehicles with petrol engine → Rep. Gr.24 and in vehicles with diesel engine → Rep. Gr.23
–  Lay out sufficient lint free clothes in area of engine and right drive shaft.
–  Draw off as much brake fluid as possible from brake fluid reservoir.
–  Clamp off clutch master cylinder supply hose using hose clamp up to Ø -3094-.
–  Pull off clutch master cylinder supply hose.
–  Pull connector off float warning indicator sender.
Vehicles with ESP:
  N40-0109
–  Pull connector -arrows- off brake pressure senders -a- and-b-.
Continuation for all vehicles:
–  Unscrew brake pipes on brake master cylinder and seal brake pipes with plugs from repair kit Part No. 1H0 698 311 A.
–  Unscrew brake master cylinder nuts.
–  Carefully take brake master cylinder out of brake servo unit.
  N47-0137

Installing > < Removing and installing brake master cylinder, right-hand drive vehicles