SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing upper transverse link|Installation >
< Removing and installing upper transverse link
Leon Mk2
Running gear
Running gear, axles, steering
Rear suspension, drive shaft
Cross beam, connecting rod (all-wheel drive) - Assembly overview / moving_and_installing_upper_transverse_link/">Removing and installing upper transverse link
Removal:
Removal:
Removal:
–
Measure the spacing from the centre of the wheel to the lower edge of the wheel housing
→ Chapter
–
Remove wheel.
–
Remove coil springs
→ Chapter
.
–
Disconnect the cable for the revolution sensor from the upper transverse swinging arm
-arrow A-
.
–
Unscrew and remove bolt
-1-
.
–
Mark, using a felt tip pen, for example, the assembly position of the off-centre bolt
-arrow-
on the strut.
–
Remove bolt
-arrow-
.
–
Remove the upper transverse swinging arm.
Running gear
Running gear, axles, steering
Rear suspension, drive shaft
Cross beam, connecting rod (all-wheel drive) - Assembly overview / moving_and_installing_upper_transverse_link/">Removing and installing upper transverse link
Removal:
Removing and installing upper transverse link|Installation >
< Removing and installing upper transverse link