seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Remove and fit the steering column with the steering mount .|Fitting > < Remove and fit the steering column with the steering mount .
Removal
Removal
  Caution
Before carrying out any work on the electrical system and disassembly of the steering wheel, the following operations should be carried out:
t  Connect the earth connection to the battery.
t  Place the wheels facing forwards.
Failure to observe these instructions can lead to failure of the Airbag system later!
Vehicles with airbag up to 08.00
–  Remove the airbag unit → Chapter.
–  Removing steering wheel → Chapter.
Vehicles with airbag from 09.00
–  Remove the airbag unit → Chapter.
–  Removing steering wheel → Chapter.
Vehicles without airbag
–  Removing steering wheel .
–  Remove the lower part of the covering for the steering column combination switch.
   
–  Remove the rubber foam tube (if fitted) from the connector and uncouple the connector -1-.
All vehicles (continued)
–  Remove the upper covering for the steering column combination switch.
–  Remove left-hand side stowage space.
  N48-0124
–  Remove the foot rest area cover, to do this, remove the screws -arrows-.
  N48-0115
–  Remove the cover -1-; by unscrewing the bolt -arrow-.
  N48-0116
–  Unscrew the bolt from the cross member -arrow-.
–  Remove the steering mount padding.
  N48-0415
–  Pull out the cable guide -1- from the steering mount.
Vehicles fitted with control unit for immobiliser
  N48-0125
–  Pull out the immobiliser control unit -1-.
Vehicles fitted with reading device for immobiliser
  N48-0126
–  Remove the immobiliser reading coil very carefully -arrow- from the steering lock casing.
  N48-0383
–  Remove the plastic cover -arrow- covering the connector of the starter and ignition switch.
–  Remove the connector from the starter and ignition switch.
All vehicles (continued)
–  Pull out the connection from the body of the steering lock.
  N48-0384
–  Drill out the rupture bolts -1- or use a suitable chisel .
  WARNING
Wear protective glasses.
–  Remove the beam articulation from the steering gear and, at the same time, extract the steering mount backwards.
–  If necessary, remove the drill bolts from the support (the second bolt cannot be seen in the diagram).
  N48-0128

Remove and fit the steering column with the steering mount .|Fitting > < Remove and fit the steering column with the steering mount .