seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Pinion with steering torque senderG269 > < Removal:

Leon Mk2

Installation
Installation
–  Insert the new seal in the servomotor with control unit
Before fitting, apply lubricant from the repair kit → Parts Catalogue to the servomotor pinion and seal.
  Caution
Never use any other type of lubricant!
   
–  Fit the servomotor with control unit to the steering casing and attach with new bolts -1- tightening diagonally.
–  Connect the sender cable connector to the power steering control unit - J500 -.
The connector should snap into place.
–  Fit the hydraulic pressure part → Chapter.
The spare part set includes, among other parts, a new hydraulic pressure part.
  N48-10194
Bolt unionThreadsTightening torque (Nm)
To subframe
→ Item		M10 x 7650+90° → Remark
To the insulating plate
→ Item		Self-threading M66
Ball joint to steering knuckle
→ Item		M12 x 1.520+90° → Remark
Track rod joint
→ Item		M16 x 1.550
Tie rod
on steering rack
→ Item		M16 x 1.5100
Crosshead to steering box → Item-30 → Remark
Pinion cover
→ Item		M6 x 2015
Pinion to bearing → ItemM10:25 → Remark
Seal bolt
→ Item		M35 x 1,565 → Remark
Servomotor with
control unit
→ Item		M8 x 3035

1)  Replace after each removal
2)  Before fitting, apply LOCTITE -5910- to the thread
–  Install steering box → Chapter.
–  Check wheel alignment → Chapter
–  Carry out the basic setting of the steering wheel angle sender -G85- using the „Guided fault finding“ of the Vehicle diagnosis testing and information system - VAS 505X-.
–  Carry out the basic setting of the steering using the „Guided fault finding“ of the Vehicle diagnosis testing and information system -VAS 505X-.
   

Pinion with steering torque senderG269 > < Removal: