Skoda Workshop Service and Repair Manuals > Fabia Mk1 > Body | Body Work | Sliding roof | Sliding/tilting roof with glass panel | Removing and installing the glass roof | Glass roof pane for sliding/tilting roof (height adjustment)

Glass roof pane for sliding/tilting roof (height adjustment)

l	The glass roof pane setting must be correct.

–	Tilt sliding/tilting roof.

–	Slide sun screen backwards.

–	Unclip bottom trim strip -1- at rear -arrow- and pull forwards away from the roof frame.

–	Unclip top trim strip -2- at front and middle and unhook at rear.

–	Release screws -1-.

–	Close sliding/tilting roof, open and close again (this sequence must be respected to obtain a correct setting).

–	Set the glass panel height at front and rear on both sides:

Front roof pane adjustment:

-a- = 0...1 mm lower than the roof

-Arrow- = direction of travel

Rear roof panel adjustment:

-b- = 0...1 mm higher than roof

-Arrow- = direction of travel

–	Tighten glass panel screws. Tightening torque 4.5 Nm.

–	Adjust the left and right side symmetrically.

Note

Inspect the height adjustment by opening and closing the sliding/tilting roof.

–	Tilt sliding/tilting roof.

–	Hook on top trim strip -2- at rear and middle and clip on at front.

–	Slide the bottom trim strip -1- towards -direction of arrow- the rear and hook on in front area.

Skoda Workshop Service and Repair Manuals