Fabia Mk1
| Summary of components - Electrical/electronic components and fitting locations of ABS/ESP systems BOSCH 5.7 |
| All components marked with 1) can be tested using the vehicle system tester -V.A.G 1552- or the fault read-out scan tool -V.A.G 1551- or using the vehicle diagnosis, measurement and information system -VAS 5051-. |
| 1 - | Hydraulic control unit BOSCH 5.7 1) |
| q | fitted until CW 21/2004 |
| q | different versions: |
| t | for ABS and ABS/EDL/TCS BOSCH 5.7 without brake pressure sender 1 -G201- |
| t | for ABS/EDL/TCS/ESP BOSCH 5.7 with brake pressure sender 1 -G201- |
| t | Distinguishing features → Chapter |
| q | Fitting position: in right of engine compartment |
| q | removing and installing → Chapter |
| q | disassembling and assembling → Chapter |
| ABS/EDL/TCS/ESP BOSCH 5.7 must not be disassembled and repaired |
| 2 - | Brake pressure sender 1 -G201- 1) |
| q | only on vehicles with ABS/EDL/TCS/ESP BOSCH 5.7 |
| q | Fitting location: screwed into the hydraulic control unit |
| q | removing and installing → Chapter |
| q | must only be replaced, but not repaired |
| 3 - | Brake servo unit with master brake cylinder and brake fluid reservoir |
| 4 - | Traction control system switch -E132 - or TCS and ESP button -E256- |
| q | Fitting location: centre part of dash panel above radio |
| q | Operation: Switching off the TCS or ESP function |
| q | can be checked in the measured value block → Chapter and in the electrical test → Chapter |
| q | removing and installing → Electrical System → Rep. gr.96 |
| 5 - | Traction control system warning light -K86- or ESP and TCS warning light -K155- |
| q | Fitting location: in the dash panel insert |
| Operation: |
| q | The warning light lights up: |
| t | for about 2 seconds after ignition is switched on |
| t | if fault is detected in TCS or ESP operation |
| t | after switching the traction control system switch or TCS and ESP button to „OFF“ |
| → Chapter |
| q | The warning light flashes: |
| t | during TCS/ESP control |
| 6 - | ABS warning light -K47- |
| q | Fitting location: in the dash panel insert |
| Operation: |
| q | The ABS warning light lights up: |
| t | for about 2 seconds after the ignition is switched on or the engine is started |
| t | if a fault is detected, e.g. open circuit to wheel speed sensor |
| → Chapter |
| 7 - | Dual circuit and hand brake system warning light -K7- |
| q | Fitting location: in the dash panel insert |
| Operation: |
| q | Dual circuit and hand brake system warning light: |
| t | lights up if hand-brake is applied |
| t | flashes if low brake fluid level |
| t | lights up for about 2 seconds after ignition is switched on |
| t | lights up if the electronic brake pressure distribution fails, i.e. when the ABS warning light -K47- comes on |
| → Chapter |
| 8 - | Dash panel insert |
| q | fitted up to model year 2004 |
| 9 - | Steering angle sender -G85-1) |
| q | only on vehicles with ABS/EDL/TCS/ESP BOSCH 5.7 |
| q | Fitting location: on the steering column between the steering wheel and the steering column switch |
| q | can be checked in the measured value block → Chapter |
| q | removing and installing → Chapter |
| 10 - | Diagnostic connection |
| q | Fitting location: in the storage compartment on the driver's side |
| 11 - | Wheel hub with wheel bearing |
| q | Sensor ring for ABS is built into the wheel hub |
| t | removing and installing: can only be replaced together with wheel hub and wheel bearing → Chapter |
| 12 - | Rear right and rear left wheel speed sensors -G44/G46-1) |
| q | removing and installing (disc brake or drum brake) → Chapter |
| q | Rear wheel speed sensor cables |
| t | removing and installing (disc brake or drum brake) → Chapter |
| 13 - | Switch for hand-brake control -F9- |
| q | Fitting location: on handbrake lever |
| q | can be checked in the measured value block → Chapter and in the electrical test → Chapter |
| q | removing and installing → Chapter |
| 14 - | Lateral acceleration sender -G200- and yaw rate sender -G202-1) |
| q | only on vehicles with ABS/EDL/TCS/ESP BOSCH 5.7 |
| q | Fitting location: under the left front seat |
| q | both senders are integrated in one housing |
| q | can be checked in the measured value block → Chapter |
| q | removing and installing → Chapter |
| 15 - | Brake light switch -F-1) |
| q | Assignment → Electronic Catalogue of Original Parts |
| q | is open in the off position |
| t | adjust → Chapter |
| t | removing and installing → Chapter |
| t | replace after each removal |
| q | can be checked in the measured value block → Chapter and in the electrical test → Chapter |
| 16 - | Wheel hub with wheel bearing |
| q | Sensor ring for ABS is built into the wheel hub |
| t | removing and installing: can only be replaced together with wheel hub and wheel bearing → Chapter |
| 17 - | Front right and front left wheel speed sensors -G45/G47-1) |
| q | removing and installing → Chapter |
| q | Front wheel speed sensor cables |
| t | removing and installing → Chapter |