Fabia Mk1
Assembly overview of the foot controls, brake pedal - RHD version |
Caution
|
Note
t | Replace self-locking nuts each time they are removed. |
t | Grease all bearing points and contact surface of the brake light switch tappet before assembly with polycarbamide grease -G 052 142 A2-. |
1 - | Bearing bracket |
q | for foot controls |
q | Crash strut cannot be removed, as it is a component part of the bearing bracket |
q | removing and installing → Chapter |
2 - | Self-locking nut, 25 Nm |
q | replace after each removal |
3 - | Self-locking nut, 28 Nm |
q | replace after each removal |
q | 4 pieces for securing the brake servo unit to the bracket |
q | 2 pieces for securing the bracket to the assembly plate |
4 - | Brake light switch |
q | Assignment → Electronic Catalogue of Original Parts |
q | before assembling the brake light switch clip brake pedal to the pressure rod of the brake servo unit |
q | Setting, removing and installing the brake light switch → Chapter |
q | Check operation of the brake lights → Chapter |
5 - | Accelerator pedal with accelerator pedal position sender -G79- and - G185- |
q | removing and installing → Engine, Mechanics; Rep. gr.20 |
6 - | Brake pedal |
q | removing and installing → Chapter |
7 - | Bushing |
8 - | Cap |
9 - | Bearing bolt |
10 - | Screw |
11 - | Brake servo unit |
q | removing and installing → Chapter |
q | Assignment → Electronic Catalogue of Original Parts |
12 - | Front wall |
13 - | Self-locking screw, 10 Nm |
q | replace after each removal |
14 - | Central pipe |
15 - | Bracket |
q | for crash strut |