Fabia Mk1 Drive Unit: Mixture Preparation System for Fuel Injection
| Overview of fitting locations |
| 1 - | Connector |
| q | for lambda probe -G39- and heating for lambda probe -Z19- before catalyst |
| q | 4-pin: on engines with identification characters ARV, AME, AZE |
| q | 6-pin: on engines with identification characters AQV, ATZ, AQW, AZF |
| 2 - | Intake manifold pressure sender -G71- with intake manifold temperature sender -G72- |
| q | under throttle valve |
| 3 - | Throttle valve control unit -J338- |
| q | with throttle valve drive for electronic power control -G186-, angle sensor 1 for throttle valve drive for electronic power control -G187- and angle sensor 2 for throttle valve drive for electronic power control -G188- |
| q | after replacing, the engine control unit must be adapted → Vehicle diagnosis, testing and information system VAS 5051 |
| 4 - | Knock sensor 1 -G61- |
| q | in cylinder block, on left below exhaust manifold |
| q | removing and installing → Chapter |
| 5 - | Coolant temperature sender -G62- |
| 6 - | Engine control unit -J361- |
| q | in plenum chamber |
| q | replace → Chapter |
| 7 - | Engine speed sender -G28- |
| q | in gearbox housing |
| 8 - | Ignition terminal (ignition transformer) with power output stage -N152- |
| q | removing and installing → Chapter |
| 9 - | Camshaft position sensor -G163- |
| q | in cylinder block |
| 10 - | Injection valves -N30...N33 - |
| q | removing and installing → Chapter |
| 11 - | Solenoid valve 1 for activated charcoal filter -N80- |
|
|