skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Fault Table and Initiating Basic Setting > < Interrogating fault memory
Erasing fault memory
Erasing fault memory
Test conditions
l  Fault eliminated
l  Fault memory interrogated → Chapter
  Note
After fault elimination the fault memory must again be interrogated and subsequently erased.
–  Press 0 and 5 for the function “Erase fault memory” and confirm the entry with Q.
   
Readout on display:
  Note
The fault memory is not erased if the ignition is switched off between “Interrogating the fault memory” and “Erasing the fault memory”.
–  Select function 06 “End output” and confirm entry with Q.
–  Perform a test drive. Again interrogate the fault memory. No fault must be displayed.
  Note
Comply with the safety instructions for test drives → Chapter.
 
Vehicle system test                   ->
The fault memory is erased

Fault Table and Initiating Basic Setting > < Interrogating fault memory