Fabia Mk1
| For engines with identification characters AWY, BMD |
| 1 - | Cylinder head cover |
| q | sealing surfaces must not be reworked. |
| q | with integrated camshaft bearings |
| q | removing and installing → Chapter |
| 2 - | 6 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| 3 - | Camshaft |
| q | removing and installing → Chapter |
| q | Pay attention to the marking → Fig. |
| q | Inspecting axial play → Fig. |
| 4 - | Roller rocker arm |
| q | do not get them confused with each other. |
| q | inspect roller bearings |
| q | oil contact surface |
| q | for installing, clip onto hydraulic supporting element with locking clips |
| 5 - | Supporting element |
| q | do not get them confused with each other. |
| q | with hydraulic valve clearance compensation |
| q | oil contact surface |
| 6 - | Valve collets |
| 7 - | Valve spring retainer |
| 8 - | Valve spring |
| q | replace springs as a set only |
| q | removing and installing → Chapter |
| 9 - | Valve stem seal |
| q | replace → Chapter |
| 10 - | Cylinder head |
| q | sealing surfaces on the camshaft side must not be reworked. |
| q | inspecting valve guides → Chapter |
| 11 - | Valve |
| q | do not re-mill, only grinding with the valve seat is permissible |
| q | Valve dimensions → Fig. |
| q | reworking valve seats → Chapter |
|
|
Note
|
|
| Dimension | Inlet valve | Exhaust valve | |
| Ø a | mm | 34,5 | 28 |
| Ø b | mm | 5,98 | 5,96 |
| c | mm | 99,25 | 99,25 |
| α | ∠° | 45 | 45 |
