skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the slave cylinder|Install > < Removing and installing the slave cylinder

Fabia Mk2

Removing
Removing
  Note
If the battery earth strap is disconnected and connected, carry out additional operations → Electrical System; Rep. gr.27.
–  Disconnect the battery-earth strap with the ignition off → Electrical System; Rep. gr.27.
–  Remove engine cover → engine; Rep. gr.10.
–  Remove air filter → Engine; Rep. gr.23 or → Engine; Rep. gr.24.
–  Remove battery and battery tray → Electrical System; Rep. gr.27.
   
–  Remove circlip -arrow 1- for shift cable from gearbox shift lever -A-.
Vehicles Fabia II and Roomster up to 05.07 and vehicles Rapid (metal relay lever)
–  Remove circlip -arrow 2- for selector cable from relay lever -B-.
–  Remove selector cable and shift cable from the studs.
–  Detach circlip -arrow 3- from the relay lever -B- and remove relay lever.
Vehicles Fabia II and Roomster as of 06.07 (plastic relay lever)
–  Pull off shift cable from the stud.
–  Remove relay lever together with cable lock → Chapter.
Continued for all vehicles
–  Remove the gearshift lever -A-, for this step unscrew nut -arrow 4-.
  N34-1820
–  Disconnect the Bowden cable support from gearbox -arrows-.
–  Tie up shift cable and selector cable.
–  Place a non-fluffing cloth under the slave cylinder.
  Note
Make sure no brake fluid comes into contact with the gearbox. If this is the case, this point must be cleaned thoroughly.
–  Pinch off the tube-hose line to the master cylinder with the hose clamp -MP7-602 (3094)- (if the tube-hose line to the master cylinder is made out of plastic, do not use the hose clamp -MP7-602-).
  S34-1094
–  Pull retaining clip -A- for tube-hose line out of the slave cylinder up to the stop.
–  Pull tube-hose line out of the support -C-.
–  Pull tube-hose line -B- out of the slave cylinder and close opening in a suitable manner.
–  Unscrew slave cylinder -arrows- and take out.
  Note
Do not depress the clutch pedal.
  S30-0140

Removing and installing the slave cylinder|Install > < Removing and installing the slave cylinder