| Removing and installing the slave cylinder |
| Special tools and workshop equipment required |
| t
| Hose clamp -MP7-602 (3094)- |
Note | t
| If the slave cylinder must be replaced due to a predetermined fault, first of all check the hydraulic clutch control → Chapter. |
| t
| If the slave cylinder with the connected tube-hose line is removed from the gearbox, do no longer depress the clutch pedal. Otherwise, the piston can be pressed out of the slave cylinder and thus be destroyed. |
| t
| When performing the following work, make sure no brake fluid comes into contact with the gearbox. If this is the case, these points must be cleaned thoroughly. |
|
|
|
