Skoda Workshop Service and Repair Manuals

Replacing inlet camshaft seal Removing –  Remove the ribbed V-belt → Chapter.

–  Disconnect plug connector from Hall sender -G40--arrow-. –  Remove top toothed belt guard. –  Remove the hall sender and the trim.

–  Screw in the screw -MP1-215/1- by hand in the crankshaft up to the stop. –  Turn inner part of gasket ring extractor -MP1-215- two turns (approx. 3 mm) out of the outer part and lock with knurled screw.

–  Oil the thread head of the gasket ring extractor -MP1-215-, position and forcefully screw it into the gasket ring as far as possible. –  Slacken knurled screw and screw in inner part of gasket ring extractor against the camshaft until the gasket ring is pulled out. Install elastomer gasket ring. –  Lightly oil the lip of the gasket ring.

–  Fit the insertion sleeve -MP1-228/2- on the camshaft stub. –  Position gasket ring over insertion sleeve onto the camshaft stub and remove sleeve.

–  Press in the gasket ring with insertion sleeve -MP1-228/1- and screw -MP1-228/3- up to the stop. Install PTFE gasket ring   Note Do not oil sealing lips of the gasket ring. –  Remove oil residue on the camshaft stud with a clean cloth.

–  Insert guide bushing -T10071/5- on the camshaft stub. –  Position gasket ring over the guide bushing onto the camshaft stub and remove sleeve.

–  Press in the gasket ring with pressure bushing -T10071/3- and screw M8 x 60 up to the stop. Proceed as follows for both versions –  Place the trim for the hall sender with the peg in the notch of the inlet camshaft. –  Install the disc (with the cone pointing outwards) and tighten up with the fixing screw to 25 Nm. –  Install hall sender and tighten to 10 Nm. –  Install top toothed belt guard. –  Plug in the plug connector for the hall sender. –  Install the V-ribbed belt → Chapter.