Removing and installing ATF pump for B2 support pipe
| l - Removing and installing ATF pump up to the support pipe for -B2- |
Note| t | Summary of components → Chapter. |
| t | Disassembling planetary gear → Anchor. |
| t | Assembling planetary gear → Anchor. |
| 1 - | Screw |
| q | tighten to 8 Nm, then torque a further 90° |
| q | tightening by 90° may occur in successive stages |
| q | 7 pieces |
| 2 - | ATF-pump with -B2- piston |
| q | assigned to gearbox identification characters as a spare part |
| q | disassembling and assembling → Chapter |
| q | for the installation of the strainer Pos. 15, a corresponding recess in the flange of the ATF pump is necessary |
| 3 - | O-ring |
| q | place on ATF pump |
| q | always replace → Electronic Catalogue of Original Parts |
| 4 - | Gasket |
| q | always replace → Electronic Catalogue of Original Parts |
| 5 - | Helical spring |
| q | 6 pieces |
| q | Insert 3 helical springs after installing the first outer plate |
| q | Install 3 helical springs for inserting the last outer plate |
| 6 - | Spring |
| q | 3 pieces |
| 7 - | Retaining loop |
| q | not installed on gearboxes with the wave spring washer on the last outer plate for brake “B2” |
| 8 - | Adjusting washer |
| q | not installed on gearboxes with the wave spring washer on the last outer plate for brake “B2” |
| q | Determine thickness → Chapter |
| 9 - | Outer plate -B2- |
| q | always install a 3 mm thick outer plate |
| 10 - | Inner plate -B2- |
| q | Piece number → Chapter |
| q | place new inner plate into ATF for 15 minutes before installing |
| 11 - | Outer plate -B2- |
| q | Piece number → Chapter |
| q | always install 2 mm thick outer plates |
| 12 - | Outer plate -B2- |
| q | always place a 3 mm thick outer plate onto the support pipe |
| 13 - | Support pipe -B2- |
| q | for the plate package of -B2- |
| q | different lengths, depending on the number of installed inner plates |
| q | assigned to gearbox identification characters as a spare part |
| q | insert in such a way that the groove grips into the wedge of the free wheel |
| 14 - | Gearbox housing with installed clutches |
| 15 - | Strainer |
| q | only available as of gearbox manufacturing date 14 02 0. |
| q | Fitting position: in the return flow of the ATF radiator |
| q | for the installation of the strainer, a corresponding recess in the gearbox housing is necessary |
