Octavia Mk1
Note
|
| 1 - | Reverse gear clutch -K2- |
| q | disassembling and assembling → Chapter |
| q | install while turning until all inner plates are in mesh |
| 2 - | Adjusting washer |
| q | Determine the thickness ⇒ set clutch clearance between -K1- and -K2- → Chapter |
| q | up to 3 adjusting washers can be installed |
| 3 - | 1st up to 3rd gear - clutch -K1- |
| q | on certain gearboxes, the clutches -K1- and -K3- can be pressed together |
| q | assigned to gearbox identification characters as a spare part |
| q | press off -K1- from -K3- → Anchor |
| q | disassembling and assembling → Chapter |
| q | press on -K1- onto -K3- → Anchor |
| 4 - | O-ring |
| q | press off to replace the clutch -K1- of -K3 - → Anchor |
| q | always replace → Electronic Catalogue of Original Parts |
| 5 - | 3rd and 4th gear - clutch -K3- with turbine shaft |
| q | assigned to gearbox identification characters as a spare part |
| q | on certain gearboxes, the clutches -K1- and -K3- can be pressed together |
| q | press off -K1- from -K3- → Anchor |
| q | disassembling and assembling → Chapter |
| q | press on -K1- onto -K3- → Anchor |
| 6 - | 1st up to 3rd gear - clutch -K1- with 3rd and 4th gear - clutch -K3- with turbine shaft |
| q | on certain gearboxes, the clutches -K1- and -K3- can be pressed together |
| q | press off -K1- from - K3- → Anchor |
| q | press -K1- onto - K3- → Anchor |
| q | insert while turning until all inner plates are in mesh |
| 7 - | Axial needle bearing with washer |
| q | Coat washer with ATF until the bearing adheres to the 3rd and 4th gear-clutch |
| q | Axial needle bearing points to the small drive shaft Pos. 8 |
| 8 - | Drive shaft, small |
| 9 - | Needle bearing |
| 10 - | Axial needle bearing |
| 11 - | Drive shaft, large |
| 12 - | Axial needle bearing |
| 13 - | Washer for axial needle bearing |
| q | with collar |
| q | Fitting position: collar points to the large sun gear Pos. 14 |
| 14 - | Sun gear, large |
| 15 - | Axial needle bearing |
| 16 - | Washer for axial needle bearing |
| 17 - | Gearbox housing with installed free wheel and circlips |
