Yeti
|
|
|
| Pos. | Screw | Pieces | Nm |
| 1 | M12 x 60 | 3 | 80 |
| 21)2) | M12 x 55 | 1 | 80 |
| 31)2) | M12 x 150 | 1 | 80 |
| 4 | M12 x 70 | 1 | 80 |
| 43) | M12 x 80 | 1 | 80 |
| 5 | M10 x 35 | 2 | 40 |
| A | Dowel sleeves | 2 |
| 1) Screw with threaded pin M8 |
| 2) Additional starter to gearbox |
| 3) Screw above the flange shaft |
|
|
| Pos. | Screw | Pieces | Nm |
| 1 | M12 x 50 | 3 | 80 |
| 21)2) | M12 x 55 | 1 | 80 |
| 31)2) | M12 x 150 | 1 | 80 |
| 4 | M12 x 60 | 1 | 80 |
| 43) | M12 x 60 | 1 | 80 |
| 5 | M10 x 50 | 2 | 40 |
| A | Dowel sleeves | 2 |
| 1) Screw with threaded pin M8 |
| 2) Additional starter to gearbox |
| 3) Screw above the flange shaft |
|
|
| Screws -arrows°2- | 40 Nm + 90° |
|
| Screws -arrows°1- | 60 Nm + 90° |
| Tightening torques |
| Component | Tightening torque |
| Cable support to gearbox | → Chapter |
| Gearbox shift lever to gearshift shaft | → Chapter |
| Slave cylinder to gearbox | → Chapter |
| Pendulum support1) | → Engine; Rep. gr.10 |
| Screen cap of drive shaft to engine | → Chassis; Rep. gr.40 |
| Drive shaft to flange shaft | → Chassis; Rep. gr.40 |
| Wheel bolts to wheel hub | → Chassis; Rep. gr.44 |
| 1) Always replace these screws → Electronic Catalogue of Original Parts. |
