Yeti
| Summary of components - Hydraulic (right-hand drive) |
| 1 - | Brake fluid reservoir |
| q | test tightness → Chapter |
| 2 - | Gasket |
| q | for plastic return hose |
| q | the gaskets must be located in the return hose |
| 3 - | Tubing |
| q | to the brake fluid reservoir |
| q | out of rubber |
| q | on certain vehicles out of plastic → Fig. |
| q | if the intake hose is made out of plastic, do not use hose clamp -MP7–602- |
| q | test tightness → Chapter |
| 4 - | Master cylinder |
| q | removing and installing (Octavia II) → Chapter |
| q | removing and installing (Superb II) → Chapter |
| q | removing and installing (Yeti) → Chapter |
| q | test tightness → Chapter |
| q | after installing, bleed the clutch control → Chapter |
| 5 - | Clamp |
| q | to remove and install the tube-hose line pull out retaining clip up to the stop |
| 6 - | Gasket ring/O-ring |
| q | pull onto line connection |
| q | insert with brake fluid |
| q | Gasket rings/O-rings adapted to the material of the line connection → Fig. |
| q | Assignment → Electronic Catalogue of Original Parts |
| q | test tightness → Chapter |
| 7 - | Support |
| q | for removing and installing, separate the master cylinder from the clutch pedal (Octavia II) → Chapter |
| q | for removing and installing, separate the master cylinder from the clutch pedal (Superb II) → Chapter |
| q | for removing and installing, separate the master cylinder from the clutch pedal (Yeti) → Chapter |
| 8 - | Clutch pedal |
| q | removing and installing (Octavia II) → Chapter |
| q | removing and installing (Superb II) → Chapter |
| q | removing and installing (Yeti) → Chapter |
| 9 - | 20 Nm |
| q | 3 pieces |
| q | self-locking |
| q | for bracket on front wall |
| q | replace → Electronic Catalogue of Original Parts |
| 10 - | Support |
| q | Mounted at the structure |
| 11 - | Tube-hose line |
| q | Assignment → Electronic Catalogue of Original Parts |
| q | Remove battery and battery tray for removing → Electrical System; Rep. gr.27 |
| q | test tightness → Chapter |
| 12 - | Support |
| q | attached to the bracket for ABS/EDL |
| 13 - | Support |
| q | for ABS/EDL |
| 14 - | Gasket ring/O-ring |
| q | pull onto line connection |
| q | insert with brake fluid |
| q | Gasket rings/O-rings adapted to the material of the line connection → Fig. |
| q | Assignment → Electronic Catalogue of Original Parts |
| q | test tightness → Chapter |
| 15 - | Clamp |
| q | to remove and install the tube-hose line pull out retaining clip up to the stop |
| 16 - | Slave cylinder |
| q | removing and installing (Octavia II) → Chapter |
| q | removing and installing (Superb II) → Chapter |
| q | removing and installing (Yeti) → Chapter |
| q | test tightness → Chapter |
| q | after installing, bleed the clutch control → Chapter |
| 17 - | Vent valve |
| q | Bleed the clutch control → Chapter |
| q | test tightness → Chapter |
| 18 - | Dust cap |
| 19 - | Gearbox |
| 20 - | 20 Nm |
| 21 - | Support |