SVX LSi AWD L6-3.3L DOHC (1997)
1. Apply grease to oil seal lip. Drive cover and spacer into place as shown in figure.
2. Place installer D (927520000) on hand press. Set ball bearing packed with grease into installer and put spacer on it.
3. Place installer E onto pinion & valve assy with valve sleeve removed. Carefully press installer into place.Set pinion pin into slot on installer E end
surface.
4. Install retaining ring.
5. Install valve in such a way that when valve sleeve is removed, pin groove is engaged properly with pinion shaft pin. (Align marking.)
NOTE: Wrong alignment will affect symmetric characteristic of valve. Make sure that the machined groove which is not marked with "x" is
properly meshed with pinion shaft.