Aerio L4-2.3L (2006)
Air Bag: Service and Repair
With Advanced Air Bag
Driver Air Bag (Inflator) Module
Driver Air Bag (Inflator) Module Removal and Installation
WARNING: When handling an air bag (inflator) module, be sure to read Precautions on Handling and Storage of Air Bag System
Components:Advanced Air Bag and observe each instruction. Failure to follow them could cause a damage to the air bag (inflator) module or
result in personal injury.
Removal
1. Disconnect negative cable at battery.
2. Disable air bag system. Refer to Disabling Air Bag System:Advanced Air Bag.
3. Loosen driver air bag (inflator) module mounting bolts (1) till it turns freely, pull them out and fix them to bolt clamps.
4. Remove air bag (inflator) module from steering wheel.
5. Disconnect driver air bag (inflator) module connectors (1) of driver air bag (inflator) module and horn connector (2) as shown in the figure.
a. Unlock lock button (3).
b. With lock button unlocked, disconnect connectors.
WARNING: Special care is necessary when handling and storing a live (undeployed) air bag (inflator) module. Observe Precautions on
Handling and Storage of Air Bag System Components:Advanced Air Bag. Otherwise, personal injury may result.
Installation
Reference: Driver Air Bag (Inflator) Module Inspection:Advanced Air Bag
1. Connect horn connector (4) securely.
