Aerio L4-2.3L (2006)
Reference: SDM Inspection:Advanced Air Bag
1. Check that none of the following faulty conditions exists.
-
Bend, scratch, deformity in vehicle body where SDM is mounted.
-
Foreign matter or rust on mating surface of vehicle body where SDM is mounted.
2. Install SDM (2) to vehicle.
CAUTION: Ensure that arrow on the SDM is pointing toward the front of the vehicle.
3. Tighten SDM bolts to specified torque.
Tightening torque
SDM bolt a: 7 N.m (0.7 kg-m, 5.0 lb-ft)
4. Connect SDM connector (1) to SDM (2) securely.
5. Install center console box upper cover.
6. Enable air bag system referring to Enabling Air Bag System:Advanced Air Bag.
7. Connect negative cable at battery.
OCM
OCM Removal and Installation
WARNING: As Occupant Classification Module (OCM) consists of precision parts, be careful not to expose it to excessive shock.
Be sure to read Precautions on Service and Diagnosis of Air Bag System:Advanced Air Bag before starting to work and observe every
precaution during work. Neglecting them may result in personal injury or inactivation of the air bag system when necessary.
NOTE: When OCM is replaced with a new one and the ignition switch is turn on, the AIR BAG warning lamp keeps on flashing. At this time, be sure to
perform rezeroing of the passenger seat occupant classification system referring to Occupant Classification System Rezeroing:Advanced Air Bag.
Removal
1. Disconnect negative cable at battery.
2. Disable air bag system referring to Disabling Air Bag System:Advanced Air Bag.
3. Disconnect seat harness.
4. Remove passenger seat referring to Front Seat Removal and Installation:Sedan.
5. Remove passenger seat undercover.
6. Disconnect OCM connector (1) from OCM (2).
7. Using flat end rod or the like (3), remove OCM (2) from passenger seat.
Installation
Reference: OCM Inspection:Advanced Air Bag
1. Install OCM to passenger seat.
