Swift L4-1298cc 1.3L SOHC MFI (1997)
6. Torque lower mount nut of knuckle to specification.
Tightening Torque:
(a): 40 - 60 Nm (29.0 - 43.0 ft. lbs.)
(b): 50 - 70 Nm (36.5 - 50.5 ft. lbs.)
7. Apply water tight sealant to mating surfaces of brake back plate and rear knuckle.
"A": Sealant 99000-31090 or equivalent.
8. Install brake back plate and tighten back plate bolts to specified torque.
Tightening Torque (c): 18 - 28 Nm (13.5 - 20.0 ft. lbs.)
9. Install brake hose bracket to knuckle.
10. Tighten brake pipe flare nut to specified torque and install bleeder plug cap taken off from pipe back to bleeder plug.
Tightening Torque (d): 14 - 18 Nm (10.5 - 13.0 ft. lbs.)
11. For ABS equipped vehicle, connect coupler of ABS wheel speed sensor.
12. For vehicles equipped with wheel hub: Install wheel hub. Refer to Transmission and Drivetrain.
13. Install brake drum. Refer to Brakes and Traction Control.
14. Install control rod and control rod nuts (inside & outside) and tighten them to such extent that they can be turned by hand.
15. Fill reservoir with brake fluid and bleed brake system. Refer to Brakes and Traction Control.
16. Upon completion of all jobs, depress brake pedal with about 30 kg (66 lbs.) load three to five times so as to obtain proper drum-to-shoe clearance.
