SX4 4WD L4-2.0L (2008)
NOTE: Be sure to check each of these parts for deterioration or any damage before installation and replace if found defective.
7. Install cylinder head cover to cylinder head.
8. Tighten cylinder head cover nuts in such order as indicated in the figure a little at a time till they are tightened to specified torque.
^
Use new seal washers.
Tightening torque
Cylinder head cover nut a: Tighten 11 Nm (1.1 kgf-m, 8.0 ft. lbs.) by the specified procedure
