Camry Wagon L4-2.0L (3S-FE) (1990)
(b) Using SST, disconnect the tie rod end from the steering knuckle
SST 09628-62011
6. DISCONNECT STEERING KNUCKLE FROM LOWER BALL JOINT
Remove the two bolts and disconnect the steering knuckle from lower ball joint
7. DISCONNECT DRIVE SHAFT FROM AXLE HUB
Using a plastic hammer, disconnect the drive shaft from the axle hub.
NOTICE: Cover the drive shaft boot with cloth to protect it from damage.
8. REMOVE LH DRIVE SHAFT
Using hub nut wrench and hammer handle or an equivalent, remove the front drive shaft as shown.
HINT: Be careful not to damage the dust cover.
9. REMOVE RH DRIVE SHAFT
(a) Remove the drive shaft.
(b) Remove the three bolts, bearing bracket and stay.