Venza AWD V6-3.5L (2GR-FE) (2010)
(c) Push in the No. 2 oil level dipstick guide end into the oil level dipstick guide.
(d) Install the No. 2 oil level dipstick guide with the bolt.
Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)
(e) Install the oil level dipstick.
5. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) See: Powertrain Management/Computers and Control Systems/Oxygen
Sensor/Service and Repair/Air Fuel Ratio Sensor/Installation
6. INSTALL NO. 2 MANIFOLD STAY
(a) Install the No. 2 manifold stay by tightening the bolt and nut in the order shown in the illustration.
Torque : 34 Nm (347 kgf-cm, 25 ft-lbf)
7. INSTALL FRONT EXHAUST PIPE ASSEMBLY See: Exhaust Pipe/Service and Repair/Installation
8. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) See: Powertrain Management/Computers and Control Systems/Oxygen
Sensor/Service and Repair/Air Fuel Ratio Sensor/Installation
9. INSTALL EXHAUST MANIFOLD TO HEAD GASKET
(a) Install a new exhaust manifold to head gasket.
10. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH
(a) Using a 12 mm deep socket wrench, install the exhaust manifold sub-assembly RH by tightening the 6 nuts in the order shown in the
illustration.