Venza AWD V6-3.5L (2GR-FE) (2010)
Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)
(b) Connect the air fuel ratio sensor connector (for Bank 1 Sensor 1).
11. INSTALL MANIFOLD STAY
(a) Install the manifold stay with the bolt and nut.
Torque : 34 Nm (347 kgf-cm, 25 ft-lbf)
12. INSTALL FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY
(a) Using a vernier caliper, measure the free length of the compression springs.
Minimum length:
41.5 mm (1.64 in.)
(b) If the free length is less than the minimum, replace the compression spring.
(c) Fully insert a new gasket to the front No. 3 exhaust pipe sub-assembly.
(d) Using a plastic hammer and wooden block, tap in the new gasket until its surface is flush with the front No. 3 exhaust pipe sub-assembly.