|
Rear Seal Ring – Crankshaft, Replace
 Remove
|
Remove flywheel – see operation "Flywheel, Remove and
Install".
Edge out seal ring (1) with suitable tool – ensure that
sealing surfaces are not damaged.
Clean sealing surfaces and remove gasket residues.
|
|
Install
Lightly coat sealing lip of the new seal ring with silicon
grease (white). Place seal ring over Protective Sleeve KKM-635-1
(2) and place straight in cylinder block and crankshaft.
Position Installer Sleeve KM-635-2 (3) on protective sleeve and
drive in seal ring with Drift KM-535 (4) until it sits flush in
cylinder block.
Install flywheel – see operation "Flywheel, Remove and
Install".
|
