|
Engine Damping Block, Right, Remove and
Install
 Remove
Remove air cleaner housing with air intake hose and hot film
mass air flow meter – see illustration "Air Ducts".
Remove lower engine compartment cover – see operation
"Lower Engine Compartment Cover, Remove and Install" in group
"A".
Note: The drive unit
must be aligned to the front axle body using KM-6173 and KM-6001-A
in order to ensure correct alignment of the drive unit after
releasing the fastening bolts for the right and left engine damping
blocks. The attachment of KM-6173 and KM-6001-A is described in the
following.
Install
|
Attach KM-6173 (3) to front axle body – screw up support
bearing (2) until pin is seated flush in mount (1) on cylinder
block.
|
|
|
Release fastening bolts (arrows) for adjustment rails on
KM-6001-A (1).
Insert KM-6001-A as illustrated – pins (2) and (5) must
sit in guide holes of front axle body.
Tighten fastening bolts for adjustment rails.
Screw up front support bearing (4) and rear support bearing (3)
until contact is made with guide pins of front engine damping block
and rear engine damping block bracket – the guide pins must
seat free from play in the support bearings.
|
|
Remove
|
Detach engine damping block (1) from side member and engine
damping block support.
Remove engine damping block with bracket.
Remove engine damping block bracket (2) from engine damping
block.
|
|
Install
Attach engine damping block bracket to engine damping block
– tightening torque 55 Nm / 41 lbf. ft.
Attach engine damping block to side member – tightening
torque 35 Nm / 26 lbf. ft.
Attach engine damping block bracket to auxiliary engine damping
blocks support – tightening torque 55 Nm / 41 lbf. ft.
Remove
Remove Mount KM-6001-A and Engine Mount KM-6173.
Install
Install lower engine compartment cover – see operation
"Lower Engine Compartment Cover, Remove and Install" in group
"A".
Install air cleaner housing with air intake hose and hot film
mass air flow meter – see illustration "Air Ducts".
|
