|
Apply a bead of adhesive sealing compound (black) to joints
(arrows) of timing case and rear crankshaft bearing cap.
Attach oil pan to transmission, cylinder block and timing case
with new gasket.
Installation sequence:
| 1. |
Tighten all bolts loosely. |
| 2. |
Tighten bolts on cylinder block and timing case
– tightening torque 20 Nm / 15 lbf. ft. |
| 3. |
Tighten bolts on transmission housing –
tightening torque (M8) 20 Nm / 15 lbf. ft. and (M10) 40 Nm / 29.5
lbf. ft. |
Connect wiring harness plugs to dynamic oil level control and to
oil temperature sensor.
Install oil drain bolt with new seal ring – tightening
torque 10 Nm / 7.5 lbf. ft.
Install lower engine compartment cover – see operation
"Lower Engine Compartment Cover, Remove and Install" in group
"A".
Fill with prescribed oil quantity.
|
