Engine Vent Flange, Remove and Install
Remove
For Z 20 LET engine: Remove air intake pipe (4) – see
illustration "Air Duct (Z 20 LET)".
Remove engine vent hose (3).
For Z 20 LET engine: Remove front coolant pipe (1) with engine
transport shackle from cylinder head and lay aside. Detach heat
shield (2) from exhaust manifold and remove.
|
|
Remove fastening bolts (1) and remove engine vent flange.
Clean
Clean sealing surfaces.
Install
Insert new gasket (2) – note installation position,
channel (3) must point upwards to engine vent flange.
Attach engine vent flange to cylinder block – tightening
torque 25 Nm / 18 lbf. ft.
|
|
For Z 20 LET engine: Attach heat shield to exhaust manifold
– tightening torque 9 Nm / 6.6 lbf. ft. Attach front coolant
pipe with engine transport shackle to cylinder head –
tightening torque 20 Nm / 14.7 lbf. ft.
Install engine vent hose.
For Z 20 LET engine: Install air intake pipe – see
illustration "Air Duct (Z 20 LET)".
|