|
Thermostat, Remove and Install
Note: The thermostat
is only supplied in assembly with the thermostat housing for
warranty reasons.
 Remove
Open coolant drain bolt – collect escaping coolant.
|
Detach coolant hoses (1) from thermostat housing.
Detach thermostat housing (2) from cylinder head.
|
|
 Clean
Clean sealing surfaces and remove gasket residues.
Install
Attach thermostat housing to cylinder head with new seal ring
– tightening torque 15 Nm / 11 lbf. ft.
Attach coolant hoses to thermostat housing.
Close coolant drain bolt.
Inspect
Charge and bleed cooling system – see operation "Cooling
System, Charge and Bleed" and "Cooling System, Check for
Leaks".
|
