|
Immobiliser Control Unit, Remove and Install
Caution
The security code must be reset with TECH 2 before removing the
immobiliser control unit when replacing or swapping immobiliser
control unit – see corresponding Checking Procedures.
 Remove
|
Remove signal switch panelling –
5 fastening bolts (arrows). Detach ignition key (3) and ignition
lock trim (2).
|
Version I:
|
|
Release and disconnect wiring harness plug. Unclip and
disconnect immobiliser control unit (1) from ignition lock housing
(5).
|
|
Version II with catch lugs (arrow):
|
|
Remove lock cylinder (4) – see operation "Lock Cylinder
for Steering / Ignition Lock, Remove and Install" in group "N".
Detach immobiliser control unit from ignition lock housing.
|
|
National version: remove protective cap (6). Unlock and detach
wiring harness plug.
|
|
|
Install
|
Version I:
|
|
Clip immobiliser control unit to ignition lock housing. Connect
wiring harness plug.
|
|
Version II:
|
|
Connect wiring harness plug. National version: connect
protective cap.
|
|
Connect immobiliser control unit to ignition lock housing.
|
|
Connect lock cylinder for steering / ignition lock.
|
Attach signal switch panelling, install
ignition lock trim.
- The ignition lock trim for Version I can only be used for this
version.
- The ignition lock trim for Version II can be used for Version I
and II.
|
|
|
