Insert housing with piston for multi-plate clutch C2 (1), as
shown, in fluid pump.
Caution
When inserting in fluid pump, ensure that the slotted seal rings
(x 2) are not damaged.
Remove
Remove piston for multi-plate clutch C2 (2) – blow in low
pressure compressed air. Replace piston seal rings (3 and 4)
– coat with transmission fluid before installation. Use
KM-994.
Inspect
Lock ball of piston for multi-plate clutch C2 – shake
piston (5) to check whether lock ball is movable. Check return
spring assembly for damage, replace if necessary. Check sliding
surfaces of steel and lining plates for damage and wear, replace if
necessary. New lining plates must be laid in transmission fluid for
at least two hours before installation.
|