|
Replace drive shaft (F17+)
Note: Transmission
remains installed.
 Remove
|
| 1. |
Remove shift mechanism cover (1)
| • |
see operation "Gearshift Cover, Remove and Install and/or Seal
(F13/F17/F17+/F18)"
|
|
| 2. |
Remove reversing lamp switch (2)
| • |
Disconnect reversing lamp (3) switch wiring harness plug
|
| • |
Unscrew reversing lamp switch
|
|
| 3. |
Remove end shield (4) cover
| • |
See operation "Gasket for End Shield Cover, Replace
(F13/F17/F17+/F18)".
|
|
| 4. |
Remove end shield (5)
| • |
See operation "Gasket for End Shield, Replace
(F13/F17/F17+/F18)".
|
|
|
| 5. |
Remove drive shaft (1)
| • |
see operation "End Shield, Dismantle and Assemble (F17+)"
|
|
|
|
Install
Important: If gear cluster teeth
are damaged, always check the corresponding gear on the main shaft
and replace if necessary.
|
| 6. |
Install drive shaft (1)
| • |
see operation "End Shield, Dismantle and Assemble (F17+)"
|
|
|
| 7. |
Install end shield (1)
Important: Note magnet.
|
| • |
See operation "Gasket for End Shield, Replace
(F13/F17/F17+/F18)".
|
|
| 8. |
Fit end shield (2) cover
| • |
See operation "Gasket for End Shield Cover, Replace
(F13/F17/F17+/F18)".
|
|
| 9. |
Fit gearshift cover (5)
| • |
see operation "Gearshift Cover, Remove and Install and/or Seal
(F13/F17/F17+/F18)"
|
|
| 10. |
Transmission Fluid Level, Check and Correct
| • |
see operation "Transmission Fluid, Check and Correct
(F13/F17/F17+/F18)"
|
|
| 11. |
Fit reversing lamp switch (3)
| • |
insert with new seal ring
|
| • |
Tighten reversing lamp switch
| – |
Tightening torque 20 Nm
|
|
| • |
Connect wiring harness plug (4)
|
|
| 12. |
Check gearshift
| • |
Check ease of gear shifting with vehicle standing, engine
running and clutch disengaged.
|
|
|
|
