|
Detach clamp bolt (1) of shift guide clamp. Pull gearshift lever
to 4th gear position and detach shift guide from shifter rod.
Loosen and detach bellows (2) from separation surface.
Install
Slide new untwisted bellows onto shifter rod and insert in
separation surface. Slide shift guide clamp onto shifter rod
– do not tighten clamp bolt.
 Adjust
Adjust shift linkage - see operation "Shift Linkage, Adjust
(F13/F13+/F17/F17+/F18)" or "Shift Linkage, Adjust (F35)"
Torque-angle method
Clamp bolt of shift guide clamp – 12 Nm / 9 lbf. ft. +
180° to 225°.
|
