|
Steering Gear Hydraulic Lines, Remove and Install
(Vehicles with LHD, EHPS Gen. I, Delphi)
 Remove
|
If present: Remove lower engine compartment cover – for
vehicles with diesel engine: see operation "Lower Engine
Compartment Cover, Remove and Install" in group "A".
Support transmission and remove engine damping block bracket
from rear of transmission and front axle body.
Caution
Place collecting pan underneath and collect escaping hydraulic
fluid.
Remove
Detach hydraulic lines (1) and (2) from steering gear feed and
steering gear housing.
|
|
Note: New seal rings
must always be used when installing hydraulic lines.
Install
Attach hydraulic lines to steering gear feed and steering gear
housing – tightening torque 27.5 Nm / 20.5 lbf. ft.
Attach rear engine damping block bracket to transmission –
tightening torque 80 Nm / 59 lbf. ft. Attach rear engine damping
block bracket to engine damping block – tightening torque 55
Nm / 40.5 lbf. ft.
If present: Install lower engine compartment cover – for
vehicles with diesel engine: see operation "Lower Engine
Compartment Cover, Remove and Install" in group "A".
Charge and bleed hydraulic system – see operation
"Hydraulic System, Charge and Bleed (EHPS Gen. I)".
|
