Non-activated airbag driver's side, replace
Remove
1. |
Note: In vehicles with
Open and Start, care must be taken that the steering column does
not lock before the battery is disconnected
|
3. |
Wait 1 minute for airbag to deactivate
|
4. |
Remove airbag
• |
Turn steering wheel 90° (I)
|
• |
Push retaining wire in direction of steering column using small
screwdriver in service opening (II) and remove airbag module
Note: Ensure that the
retaining wire is not bent
|
• |
Release and disconnect wiring harness plug
|
|
|
|
Install
5. |
Install airbag
• |
Connect and latch wiring harness plug
|
|
6. |
Perform readiness check
|
8. |
Program volatile memories
|
|