vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

C-008 System Status Information > < C-006 Driver Outside Mirror Folding Circuit

C-007 - Front Passenger Outside Mirror Folding Circuit

Test

Work Order Description

Nominal Value

T001

Check: Interruption of Voltage Supply Circuit

  • Ignition OFF
  • Disconnect wiring harness connector from:
    S115 Switch Unit - Driver Door
  • Measure voltage between the following terminals:
    Wiring harness connector (wiring harness side) terminal 13
    &
    Ground

greater than 11 V

Voltage Measurement Current Value: V
Yes: No:
T002

Check: Circuit Interruption of Ground Circuit

  • Measure voltage between the following terminals:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 13
    &
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 32

greater than 11 V

Voltage Measurement Current Value: V
Yes: No:
T003

Check: Short to Voltage/Interruption of Signal Circuit

  • Ignition ON
  • Measure voltage between the following terminals:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal (Left Hand Driven) 22 (Right Hand Driven) 6
    &
    Ground
(Left Hand Driven)

less than 0.3 V

(Right Hand Driven)

less than 0.3 V

Voltage Measurement Current Value: V
Yes: No:
T004

Check: Short to Voltage/Interruption of Signal Circuit

  • Measure voltage between the following terminals:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal (Left Hand Driven) 23 (Right Hand Driven) 7
    &
    Ground
(Left Hand Driven)

less than 0.3 V

(Right Hand Driven)

less than 0.3 V

Voltage Measurement Current Value: V
Yes: No:
T005

Check: Interruption of Signal Circuit

  • Ignition OFF
  • Disconnect wiring harness connector from:
    M11P Mirror Unit - Passenger Door
  • Measure resistance between the following terminals:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal (Left Hand Driven) 22 (Right Hand Driven) 6
    &
    M11P.2 Motor - Parking Position, Passenger Door
    Wiring harness connector (wiring harness side) terminal (Left Hand Driven) 5 (Right Hand Driven) 6
(Left Hand Driven)

less than 5 Ohm

(Right Hand Driven)

less than 5 Ohm

Resistance Measurement Current Value: Ohm
Yes: No:
T006

Check: Interruption of Signal Circuit

  • Measure resistance between the following terminals:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal (Left Hand Driven) 23 (Right Hand Driven) 7
    &
    M11P.2 Motor - Parking Position, Passenger Door
    Wiring harness connector (wiring harness side) terminal (Left Hand Driven) 6 (Right Hand Driven) 5
(Left Hand Driven)

less than 5 Ohm

(Right Hand Driven)

less than 5 Ohm

Resistance Measurement Current Value: Ohm
Yes: No:


Result

Cause Of Fault

E001 Result: Defective Component
  • Defective component:
    S115 Switch Unit - Driver Door
    or
    M11P.2 Motor - Parking Position, Passenger Door

Note:

The replacement of the components must be done in the listed order.

The system must be checked for proper operation after every replacement.

E002 Result: Interruption
  • Circuit interruption between:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal (Left Hand Driven) 23 (Right Hand Driven) 7
    &
    M11P.2 Motor - Parking Position, Passenger Door
    Wiring harness connector (wiring harness side) terminal (Left Hand Driven) 6 (Right Hand Driven) 5
E003 Result: Interruption
  • Circuit interruption between:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal (Left Hand Driven) 22 (Right Hand Driven) 6
    &
    M11P.2 Motor - Parking Position, Passenger Door
    Wiring harness connector (wiring harness side) terminal (Left Hand Driven) 5 (Right Hand Driven) 6
E004 Result: Short to Voltage
  • Short circuit to voltage between:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal (Left Hand Driven) 23 (Right Hand Driven) 7
    &
    M11P.2 Motor - Parking Position, Passenger Door
    Wiring harness connector (wiring harness side) terminal (Left Hand Driven) 6 (Right Hand Driven) 5

or

  • Defective component:
    M11P.2 Motor - Parking Position, Passenger Door
E005 Result: Short to Voltage
  • Short circuit to voltage between:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal (Left Hand Driven) 22 (Right Hand Driven) 6
    &
    M11P.2 Motor - Parking Position, Passenger Door
    Wiring harness connector (wiring harness side) terminal (Left Hand Driven) 5 (Right Hand Driven) 6

or

  • Defective component:
    M11P.2 Motor - Parking Position, Passenger Door
E006 Result: Interruption
  • Circuit interruption between:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 32
    &
    Ground
E007 Result: Interruption
  • Circuit interruption between:
    FR26 Fuse
    Output contact
    &
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 13





C-008 System Status Information > < C-006 Driver Outside Mirror Folding Circuit