Replace moulded headlining - L69
Remove
2. |
Detach A-pillar inner panelling - both sides
• |
Unclip panel (1)
Note: Only for vehicles
with curtain airbag.
|
• |
Remove inner panelling A-pillar
|
|
|
|
3. |
Detach front seatbelt fastening (1) - both sides
• |
Unclip and remove panel upwards (arrow)
|
|
|
|
|
4. |
Detach B-pillar inner panelling - both sides
• |
Unclip panel (1)
Note: Only for vehicles
with curtain airbag.
|
• |
Remove lower B-pillar panel in upper area and remove upper
B-pillar panel
|
• |
Remove B inner panelling
|
|
|
5. |
Detach C-pillar inner panelling - left side
|
6. |
Detach upper C-pillar inner panelling - left side
|
7. |
Detach sun visor - both sides
• |
Unclip sun visor from support and remove
|
|
|
|
8. |
Remove left sun visor support
• |
Prise out main bracket wedge and remove main bracket
Note: Spring of main
bracket is not secured and may fall down.
|
|
|
|
9. |
Remove handles in moulded headlining
|
|
|
10. |
Remove rear interior lamp
• |
Unclip interior light with plastic wedge
|
• |
Disconnect wiring harness plug.
|
|
11. |
Detach interior light operating unit
• |
Disconnect wiring harness plug.
|
|
|
|
|
12. |
Loosen and remove surrounding moulded headlining
Note: 2nd mechanic
required.
• |
Disconnect wiring harness plug.
|
• |
Disconnect 6x velcro fasteners (arrows)
|
|
|
Install
13. |
Insert moulded headlining
Note: 2nd mechanic
required.
• |
Connect wiring harness plug
|
• |
Join 6x Velcro fasteners
|
|
14. |
Fasten moulded headlining all the way round
• |
Place moulded headlining in door rubber strip weatherstrip
|
|
15. |
Fasten interior light operating unit
• |
Connect wiring harness plug
|
|
16. |
Install handles in moulded headlining
|
17. |
Attach sun visor support - both sides
Note: Install wedge
with groove downwards
|
18. |
Attach sun visor - both sides
• |
Clip sun visor into main bracket
|
|
19. |
Attach C-pillar inner panelling - right side
|
20. |
Attach C-pillar inner panelling - left side
|
21. |
Attach B-pillar inner panelling - both sides
• |
Place B-pillar inner panelling, clip in upper B-pillar
panelling in lower B-pillar panelling
|
|
22. |
Attach seat belt to front seat - both sides
• |
Tighten bolt 20 Nm
Note: Use screw locking
compound
|
|
23. |
Attach front seatbelt securing panel - both sides
|
24. |
Install A-pillar moulding - both sides
• |
Clip in panel in A-pillar moulding
Note: Only for vehicles
with curtain airbag.
|
|
26. |
Program volatile memories
|
|