vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
C-097 Fuse FR27 Circuit > < C-095 Fuse FR24 Circuit

Astra H

C-096 - Fuse FR26 Circuit

Test

Work Order Description

Nominal Value
T001

Check: Short to Ground of Voltage Supply Circuit
  • Ignition OFF
  • Reconnect all disconnected components
  • All consumers turned off
  • Insert new component:
    FR26 Fuse
  • Ignition ON
  • Actuate the following component:
    S115.9 Switch - Outside Mirror Parking Position
  • Check the following component for proper operation:
    FR26 Fuse

Test okay?
Yes: No:
T002

Check: Short to Ground of Voltage Supply Circuit
  • Ignition OFF
  • Disconnect wiring harness connector from:
    S115 Switch Unit - Driver Door
  • Ignition ON
  • Insert new fuse FR26 and then check the fuse for proper operation.

Test okay?
Yes: No:
T003

Check: Short to Ground of Voltage Supply Circuit
  • Remove fused jumper wire
  • Connect fused jumper wire to:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 23
    &
    Battery voltage
  • Check the following component for proper operation:
    Fuse of the fused jumper wire

Test okay?
Yes: No:
T004

Check: Short to Ground of Voltage Supply Circuit
  • Remove fused jumper wire
  • Connect fused jumper wire to:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 7
    &
    Battery voltage
  • Check the following component for proper operation:
    Fuse of the fused jumper wire

Test okay?
Yes: No:
T005

Check: Short to Ground of Voltage Supply Circuit
  • Remove fused jumper wire
  • Connect fused jumper wire to:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 22
    &
    Battery voltage
  • Check the following component for proper operation:
    Fuse of the fused jumper wire

Test okay?
Yes: No:
T006

Check: Short to Ground of Voltage Supply Circuit
  • Remove fused jumper wire
  • Connect fused jumper wire to:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 6
    &
    Battery voltage
  • Check the following component for proper operation:
    Fuse of the fused jumper wire

Test okay?
Yes: No:
T007

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Left Hand Driven
Yes: No:
T008

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Right Hand Driven
Yes: No:
T009

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Left Hand Driven
Yes: No:
T010

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Right Hand Driven
Yes: No:
T011

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Left Hand Driven
Yes: No:
T012

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Right Hand Driven
Yes: No:
T013

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Left Hand Driven
Yes: No:
T014

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Right Hand Driven
Yes: No:


Result

Cause Of Fault
E001 Result: System Overload
  • A temporary current overload in the system behind fuse FR26 has occurred

Note:

In case of a temporary current overload, the cause for the blow of the fuse may be located in a circuit behind the control unit/component.

These circuits should be checked additionally for short to ground.
E002 Result: Defective Component
  • Defective component:
    S115 Switch Unit - Driver Door
E003 Result: Short to Ground
  • Short circuit to ground between:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 6
    &
    M11D Mirror Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 6

or

  • Defective component:
    M11D.2 Motor - Parking Position, Driver Door
E004 Result: Short to Ground
  • Short circuit to ground between:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 6
    &
    M11P Mirror Unit - Passenger Door
    Wiring harness connector (wiring harness side) terminal 6

or

  • Defective component:
    M11P.2 Motor - Parking Position, Passenger Door
E005 Invalid / not supported vehicle configuration
  • The selected Checking Procedure is not valid for this vehicle configuration.
E006 Result: Short to Ground
  • Short circuit to ground between:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 22
    &
    M11P Mirror Unit - Passenger Door
    Wiring harness connector (wiring harness side) terminal 5

or

  • Defective component:
    M11P.2 Motor - Parking Position, Passenger Door
E007 Result: Short to Ground
  • Short circuit to ground between:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 22
    &
    M11D Mirror Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 5

or

  • Defective component:
    M11D.2 Motor - Parking Position, Driver Door
E008 Result: Short to Ground
  • Short circuit to ground between:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 7
    &
    M11D Mirror Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 5

or

  • Defective component:
    M11D.2 Motor - Parking Position, Driver Door
E009 Result: Short to Ground
  • Short circuit to ground between:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 7
    &
    M11P Mirror Unit - Passenger Door
    Wiring harness connector (wiring harness side) terminal 5

or

  • Defective component:
    M11P.2 Motor - Parking Position, Passenger Door
E010 Result: Short to Ground
  • Short circuit to ground between:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 23
    &
    M11P Mirror Unit - Passenger Door
    Wiring harness connector (wiring harness side) terminal 6

or

  • Defective component:
    M11P Mirror Unit - Passenger Door
E011 Result: Short to Ground
  • Short circuit to ground between:
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 23
    &
    M11D Mirror Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 6

or

  • Defective component:
    M11D Mirror Unit - Driver Door
E012 Result: Short to Ground
  • Short circuit to ground between:
    X131 Rear Electronic Module
    Wiring harness connector (wiring harness side) terminal 9 (XR3)
    &
    S115 Switch Unit - Driver Door
    Wiring harness connector (wiring harness side) terminal 13

or

  • Defective component:
    X131 Rear Electronic Module

Important:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.





C-097 Fuse FR27 Circuit > < C-095 Fuse FR24 Circuit