Test
|
Work Order Description
|
Nominal Value
|
T001
|
Check: Short to Voltage of Voltage Supply Circuit
|
- Ignition OFF
- All consumers turned off
- Disconnect wiring harness connector from:
L2B Injection Valve - Cylinder 2 A84 Control Unit - Engine
- Ignition ON
- Measure voltage between the following terminals:
L2B Injection Valve - Cylinder 2 Wiring harness connector (wiring harness side) terminal 2 & Ground
|
less than 0.3 V
|
|
|
T002
|
Check: Short to Ground of Signal Circuit
|
- Ignition OFF
- Measure resistance between the following terminals:
L2B Injection Valve - Cylinder 2 Wiring harness connector (wiring harness side) terminal 2 & Ground
|
greater than 500 kOhm
|
|
|
T003
|
Check: Interruption of Signal Circuit
|
- Measure resistance between the following terminals:
A84 Control Unit - Engine Wiring harness connector (wiring harness side) terminal 61 (XC3) & L2B Injection Valve - Cylinder 2 Wiring harness connector (wiring harness side) terminal 2
|
less than 5 Ohm
|
|
|
T004
|
Check: Interruption of Voltage Supply Circuit
|
- Remove electrical component from socket:
K10_X125 Relay - Fuel Pump
- Connect fused jumper wire to:
K10_X125 Relay - Fuel Pump Socket Terminal 87 & Battery voltage
- Measure voltage between the following terminals:
L2B Injection Valve - Cylinder 2 Wiring harness connector (wiring harness side) terminal 1 & Ground
|
greater than 11 V
|
|
|
T005
|
Check: Component
|
- Connect wiring harness connector to:
L2B Injection Valve - Cylinder 2
- Ignition ON
- Contact fused jumper wire once to:
A84 Control Unit - Engine Wiring harness connector (wiring harness side) terminal 61 (XC3) & Ground
|
Clicking noise from the valve
|
|