Bellows on Shift Rod, Replace (F13/F13+/F17+)
Remove
1. |
Draw manual gearshift lever into 4th gear position
|
2. |
Release bolt (1) for relay point clamp
• |
Disconnect relay point from gearshift lever
|
|
3. |
Disconnect bellows (2) from bulkhead
|
|
|
Install
4. |
Attach bellows (2) to bulkhead
Note: Push bellows on
to gearshift rod without twisting it.
|
5. |
Attach transmission relay point to gearshift rod
Note: Do not tighten
clamping screw (1)
|
|
|
6. |
Transmission Shift Linkage, Adjust
|
|