vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
Heated Oxygen Sensor Replacement - 1.7L Diesel LPL and LPV > < Glow Plug Replacement - 1.7L Diesel LPL and LPV

Astra J

Crankshaft Position Sensor Replacement (1.7L Diesel LPL and LPV)



2191883




Callout
Component Name

Preliminary Procedures

1. Open the hood.
2. Disconnect the battery negative cable. Refer to . Battery Negative Cable Disconnection and Connection
3. Raise and support the vehicle. Refer to . Lifting and Jacking the Vehicle
4. If equipped, remove the engine shield. Refer to . Engine Shield Replacement
5. If equipped, open the front compartment service opening.


1
Crankshaft Position Sensor Wiring Harness Plug

Procedure

Disconnect the crankshaft position sensor wiring harness plug.

2
Crankshaft Position Sensor Bolt

Caution: Refer to Fastener Caution .

Tighten
10 N·m (89 lb in)

3
Crankshaft Position Sensor

Procedure

After the replacement of the crankshaft position sensor, use a scan tool to perform the appropriate reset function. Refer to Engine Control Module Programming and Setup .

4
Crankshaft Position Sensor Seal Ring

Procedure

Install a NEW crankshaft position sensor seal ring.
 

Heated Oxygen Sensor Replacement - 1.7L Diesel LPL and LPV > < Glow Plug Replacement - 1.7L Diesel LPL and LPV