vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
Engine Coolant Fan Shroud Replacement - 1.6L LDE, LLU and MT > < Engine Coolant Fan Shroud Replacement - LDE,LLU,LUJ,LUW, LXT,LXV,L2W,2HO-AT

Astra J

Engine Coolant Fan Shroud Replacement (1.4 L LDD)

Removal Procedure

1. Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
3. Drain the cooling system. Refer to Cooling System Draining and Filling
4. Remove the radiator inlet hose. Refer to Radiator Inlet Hose Replacement

           2028322


5. Disconnect the engine coolant fan resistor wiring harness plug (1).
6. Unclip all retainer clips and remove the wiring harness (2).

           2191512



Note:  You stand against driving direction.
7. Unclip the engine coolant fan shroud (1) at the shown four mounting points.
8. Remove the engine coolant fan shroud (1).

Installation Procedure


           2191512


1. Install the engine coolant fan shroud (1).
2. Clip in the engine coolant fan shroud (1) at the shown four mounting points.

           2028322


3. Connect the engine coolant fan resistor wiring harness plug (1).
4. Install the wiring harness (2) and clip in all retainer clips.

Caution: Refer to Fastener Caution

5. Install the ground cable and the ground cable nut and tighten to 10 N·m (89 lb in) .
6. Install the radiator inlet hose. Refer to Radiator Inlet Hose Replacement
7. Top up the cooling system. Refer to Cooling System Draining and Filling
8. Connect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection

Engine Coolant Fan Shroud Replacement - 1.6L LDE, LLU and MT > < Engine Coolant Fan Shroud Replacement - LDE,LLU,LUJ,LUW, LXT,LXV,L2W,2HO-AT