Engine Block Assemble (1.7L Diesel LPL, LPV and LUB)
|
Note: Ensure that no
dirt or metal chips contaminate the crankshaft position sensor
housing.
|
1. |
Install the crankshaft
position sensor (5). |
2. |
Install the crankshaft
position sensor bolt (6) and tighten to 10 N·m (89
lb in) . |
3. |
Install the oil pressure
relief valve (3). Install a NEW seal ring (2). |
4. |
Tighten the oil pressure
relief valve to 30 N·m (22 lb ft) .
|
5. |
Install the oil pressure check
valve (4). Install a NEW seal ring (1). |
6. |
Tighten the oil pressure check
valve to 21 N·m (15 lb ft) . |
|